← Knowledge Hub

COSHH & Hazardous Substances

Silica Dust at Work: Employer Duties and the 2026 Engineered Stone Update

Silica dust deserves attention before anyone starts cutting. Dust generated from concrete, brick, stone and similar materials can include particles small enough to reach deep into the lungs. These are known as respirable crystalline silica, or RCS, and may be invisible in normal lighting. [36]

This guide covers Great Britain and includes an update checked on 11 September 2026. Northern Ireland has separate COSHH legislation and regulator guidance.

Identify the exposure behind the task

Do not limit your COSHH register to bought-in chemicals. Cutting, grinding and drilling can generate hazardous dust from the material being worked. Include preparation, cleaning and maintenance when describing the exposure.

Ask what material is involved, how it will be processed, who could be exposed and which controls are available. “Wear a dust mask” gives no indication of whether the selected equipment or method will control that exposure.

The RCS workplace exposure limit is 0.1 mg/m³ as an eight-hour time-weighted average. [40] It is an airborne concentration limit, not a permitted silica percentage in a product or proof that a visibly clean workplace is safe. Obtain competent advice where exposure assessment or measurement is needed.

Understand what changed in 2026

In May 2026, HSE announced new engineered-stone guidance and an inspection programme. It clarified that dry cutting is unacceptable unless a business can demonstrate equally effective or better control. HSE explicitly describes this as guidance under existing legal duties, not a new law or a formal legislative ban. [37]

That distinction matters. A business should not wait for a new Act before addressing poor dust control. Equally, a headline about engineered stone should not be presented as a new blanket rule covering every material and process in the same way.

Use the guidance for the actual process

HSE's ST3A sheet addresses cutting, grinding and polishing engineered stone with powered hand-held rotary tools. It sets out low-silica material selection, on-tool water suppression, mist control and powered air-purifying respiratory protection with an assigned protection factor of at least 20. [39]

Read the whole control sheet rather than selecting one measure. Water suppression does not remove the need to consider contaminated mist, respiratory protection or exposure during cleaning. HSE's guidance also addresses health surveillance where regular exposure and a reasonable likelihood of relevant disease make it necessary. [38]

For concrete cutting, natural stone or other processes, select the relevant task guidance and assess the circumstances. One workshop's control package should not be copied across without checking what it was designed to cover.

Check the controls throughout the job

Observe the start, normal operation and finish. Confirm that the control equipment is connected, supplied and working before the tool operates. Decide what happens if water supply, extraction or respiratory protection fails.

Include people nearby. The person operating the tool may have protective equipment while another employee clears waste beside them. Cleaning and equipment maintenance need their own attention; accumulated material can become a later source of exposure. [39]

Ask supervisors to show how they know the controls are effective. Purchasing records establish that equipment exists. They do not demonstrate how it performs, whether staff use it correctly or whether changed materials have altered the risk.

FAQs

Is silica dust the same as ordinary nuisance dust?

No. RCS can cause serious lung disease, including silicosis and lung cancer. Do not judge its significance from how much dust you can see. [36,38]

Is the 2026 engineered stone guidance a new law?

No. HSE says it clarifies control expectations under existing duties. Businesses must still address those duties now. [37]

Is water suppression enough on its own?

Do not assume so. The engineered-stone guidance combines several controls and addresses mist, RPE, cleaning and health surveillance. [38,39]

How Secure Safety Solutions can help

We can help you review the COSHH assessment and management arrangements around silica-generating work, identify gaps and establish where specialist occupational hygiene or health advice is needed. Start with the material, process and controls you currently use.

Review your silica dust controls