Engineering & Automotive Safety
Welding Fumes: What Controls Should a Workshop Have?
Guidance dated 11 September 2026
A welding job should not begin until the controls for fume are ready. That applies to a workshop repair as well as a long production run. A task being familiar or brief does not remove the need to control exposure.
This article follows the Great Britain COSHH framework. Northern Ireland has separate regulations and guidance.
Include mild steel and short jobs
HSE's welding-fume enforcement bulletin includes mild steel and makes clear that suitable exposure controls are expected regardless of duration. The bulletin dates from 2019; it should not be described as a new 2026 welding law. [42]
Check whether your assessment describes the welding that actually takes place. A document covering one process may overlook maintenance repairs, subcontracted work or welding on different materials. Include nearby employees who may be exposed even though they are not holding the torch.
Consider whether exposure can be reduced earlier
Before selecting extraction, consider whether the job design can reduce the amount of welding or use a suitable lower-fume process. HSE's guidance places avoiding or reducing exposure before relying on extraction and respiratory protective equipment. [41]
The appropriate choice depends on the engineering requirements. A safety assessment should inform that decision without assuming an alternative joint will be suitable for the finished product. Bring the people responsible for design and production into the discussion.
Make extraction suit the welding
Local exhaust ventilation, or LEV, aims to capture fume where it is produced. The system needs to suit the process and working position. A unit running somewhere in the workshop does not show that fume is being captured at the weld. [41,43]
Observe a representative task. Can the operator position the extraction effectively throughout the work? Does a large component obstruct the capture point? What changes when the workpiece is turned or another station starts operating?
For example, an extraction arm may be correctly positioned for the first weld but left behind when the operator moves around a frame. Discuss the whole sequence with the equipment supplier or competent examiner rather than accepting good capture at only one position.
Address residual fume and outdoor work
Where LEV does not adequately control exposure, or providing it is not reasonably practicable, suitable RPE is needed. HSE also requires suitable RPE for outdoor welding because LEV cannot be relied on to capture the fume effectively there. Consider protection for other people nearby. [41]
Choose RPE for the exposure, wearer and work. Compatibility with eye and face protection matters. A respirator that is removed to see the job or communicate is not providing its intended protection during that period.
Keep the controls dependable
Establish checks, maintenance and the required thorough examination and testing of extraction. Train people to use the controls and recognise a fault. HSE's welding control sheet includes checking airflow and maintaining appropriate filtration. [43]
Make the response to failure clear. If extraction is ineffective, staff should know how to stop or change the work safely and who can authorise a suitable alternative. Waiting for the next scheduled service while continuing unchanged leaves the problem unresolved.
Review the assessment when the process, materials, layout or production pattern changes. Keep the operator involved; difficulties in setting up or using the controls often become apparent during ordinary work before they appear in a report.
FAQs
Does mild steel welding need fume controls?
Yes. HSE's expectations expressly include mild steel welding. [42]
Is an open roller door sufficient?
Do not assume it provides adequate control at the operator's breathing zone. Assess exposure and use suitable controls for the task. [41]
Do occasional repair welds need an assessment?
Yes. Brief duration is not a general exemption from controlling welding fume. Include repairs in your arrangements. [42]
How Secure Safety Solutions can help
We can review your COSHH documentation and workshop arrangements, connect the findings with practical actions and identify where specialist extraction or occupational hygiene input is needed. Bring the assessment and your latest control-equipment reports to the discussion.
Review your welding fume arrangements
Sources and further reading
- [41] HSE: Controlling the risks from welding
- [42] HSE: Welding fume enforcement expectations
- [43] HSE: Welding fume control sheet WL3
General guidance. The arrangements you need depend on your activities, premises and location.
